Bookcase glass cabinet door is very common in our daily life. It not only facilitates the owner to take books, but also increases the overall aesthetics of bookcase. And glass materials are not only used here, but also can be seen everywhere in home decoration. How to install the glass cabinet door?

How to install the glass cabinet door

1. Before the installation of the thick glass door, it is necessary to ensure that the ground construction has been completed and the stainless steel or other decorative door frames have been completed. The thick glass limit slot has been reserved. It is necessary to be very careful about the chamfering of four corners. Generally, hold the fine grinding wheel block by hand and grind the corner slowly to prevent the edge from collapsing. Only in this way can the wooden bottom bracket with stainless steel facing be installed and fixed on the ground with the method of wooden wedge nail. After that, the stainless steel decorative panel can be stuck on the wooden square with all-purpose glue.

2. When installing, the aluminum alloy square tube can be fixed on the frame column with aluminum angle or on the wood wedge embedded in the ground with wood screw. First use the glass sucker to tighten the thick glass, and then hold the sucker to lift the thick glass plate. Remember to lift 2-3 people at the same time.

3. Insert the raised thick glass plate into the limit slot at the top of the door frame first, then put it on the bottom bracket, and align the installation position, so that the edge of the thick glass plate just covers the butt joint of the stainless steel facing of the side frame column. Finally, open the glass glue and install it into the glass glue injection gun, and then use the back pressing rod end plate of the glass glue gun, so that the bottom of the glass glue tank can be countered. Finally, hold the injection gun body with one hand and hold the injection pressure handle, and operate the pressure handle continuously and circularly to extrude a small amount of glass glue for injection. Then align the injection port of glass glue with the gap end for sealing.

Jiangmen Jiangyi Industrial Co., Ltd.committed to the production of glass deep-processing tools & glass hardware and import and export trade, enjoying a good reputation in this industry.